|
fender spacers
I cut a bunch of varying thicknesses of aluminum to act as front fender spacers, so the fender aligns with the outer edge of the tire better. Photo taken after pieces were abrasive blasted.
Date: 09/01/2007
Views: 69
|
fender spacers powdercoated
Aluminum fender spacers after powdercoating satin black.
Date: 09/01/2007
Views: 73
|
fender spacers installed
Date: 09/01/2007
Views: 108
|
fender spacers - before and after
Before and after fender spacer installation. Aaah, much better.
Date: 09/01/2007
Views: 115
|
|
dash - before
Dash layout before modification.
Date: 03/30/2008
Views: 70
|
dash - after
Layout of dash after adding brake bias control (to easiest-to-reach location) and relocating headlight control. Never-used fog light control relocated behind dash.
Date: 03/30/2008
Views: 93
|
steering shaft
View of steering shaft and U-joint after unfastening it from dash crossmember.
Date: 04/05/2008
Views: 61
|
steering - old bushings
Steering shaft and old plastic bushings. The bushings are being replaced due to squeaking, binding, and excessive slop.
Date: 04/05/2008
Views: 58
|
|
steering - new bushing
Steering shaft and new bronze bushing. More info on the process HERE.
Date: 04/05/2008
Views: 65
|
toyo r888 - side
Toyo R888 245/45/16 on 7" wide Team Dynamics wheel.
Date: 04/19/2008
Views: 69
|
toyo r888 - fender 1
Rear fender clearance with Toyo R888 245/45/16.
Date: 04/19/2008
Views: 74
|
toyo r888 - fender 2
Rear fender coverage over Toyo R888 245/45/16.
Date: 04/19/2008
Views: 63
|
|
gauge 1
Welding up and positioning an aluminum bracket for an Aeroforce Interceptor gauge. Pic prior to trimming down bracket and powdercoating it black.
Date: 04/27/2008
Views: 76
|
gauge 4
Bracket trimmed to size, powdercoated, and fastened.
Date: 04/27/2008
Views: 71
|
gauge 2
Final position of Aeroforce Interceptor gauge.
Date: 04/27/2008
Views: 63
|
gauge 3
Aeroforce Interceptor gauge display.
Date: 04/27/2008
Views: 95
|
|
autocom
Autocom helmet intercom system mounted out of the way under the dash.
Date: 05/24/2008
Views: 82
|
sockets
For long cross-country trips, one power socket doesn't cut it so two more were added.
Date: 05/24/2008
Views: 76
|
gps mount
GPS mounting using Ram Mount gear.
Date: 06/01/2008
Views: 103
|
engine ID plate
Because of everyone's first question, I fabricated an ID plate for the motor.
Date: 09/07/2008
Views: 119
|
